Precor C842i User Manual download pdf (Page 15)

Product Owner’s Manual: Club Features 13

Informational Displays (C842i)

The C842i cycle provides information about its use (odometer and

hour meter), as well as software version, and error log. In general,

you would only access this information if directed to do so by Precor

Customer Support.

These instructions guide you through all four informational displays.

Viewing the Odometer

1. At the Precor banner, press the following keys in sequence and

without pause:

RESET, RESISTANCE ▼, SELECT

Numbers appear on the display as you press the associated key.

REVOLUTIONS appears on the display followed by the

odometer value (number of total revolutions).

2. When you are ready, press SELECT to move to the next display

(hour meter).

Viewing the Hour Meter

HOURS appears followed by the number of hours that the unit

has been in use. The cycle tracks the elapsed minutes, but the

value that appears is truncated to the nearest full hour.

3. When you are ready, press SELECT to move to the next display

(software version).

Viewing the Software Version and Part Numbers

UPPER SW scrolls across the display followed by the upper

board application software part number and version (for example,

48181-350).

4. To see the upper boot and lower boot application software

version, press the SELECT key. If needed, you can move through

all three—upper board, upper boot, and lower board—using the

SELECT key.

5. Write the numbers below. You will need these numbers when you

call Customer Support with display-related questions. This

information will help rule out any software-related problems:

Upper Software P/N: ___________________

Upper Boot Software P/N: _____________

Lower Software P/N: ___________________

6. When you are ready, press RESET to move to the next display

(error log).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

No comments

Precor C842i User Manual Page 15