Precor C954i Service Manual download pdf (Page 16)

C954, C956 Treadmill

Page 1-16 Page 16

Procedure 4.2 - Adjusting Drive Belt Tension

1. Set the treadmill circuit breaker in the “off” position and unplug the line cord from the wall

outlet.

2. Remove the hood.

3. Place the drive belt tension gauge on the drive belt as shown in Diagram 4.2.

Diagram 4.2 - Drive Belt Tension Gauge

4. The gauge should read approximately 80 inch/pounds. The drive belt tension is acceptable

if it is in the range of 70 to 90 inch-pounds.

5. Version 1 & 2 units, only. Skip to step 6 for version 3 units. If the drive belt tension is

less than 70 or greater than 90 inch/pounds, adjust the drive belt adjustment bolt until the

belt gauge reads approximately 80 inch/pounds. See Diagram 4.3. Momentarily remove the

drive belt tension gauge from the drive belt. Replace the drive belt tension gauge on the

drive belt and re-adjust the drive belt tension, if necessary. Skip to step 7.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 72 73

No comments

Precor C954i Service Manual Page 16