Precor C954i Service Manual download pdf (Page 13)

C954, C956 Treadmill

Page 13

Section Three - Checking Treadmill Operation

This section provides you with a quick method of checking treadmill operation. Check treadmill

operation at the end of a maintenance procedure and when it is necessary to ensure that the

treadmill is operating properly.

Procedure

4. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.

5. Operate the treadmill in the Manual program. Adjust the speed of the running belt to 2–3

m.p.h. Operate the treadmill for at least 5 minutes.

a. Concentrate on the feel of the running belt and the sound of the drive motor and rollers.

Be on the alert for unusual noises, smells, or vibrations.

b. Observe the LEDs on the electronic console. Make sure that each LED lights as the in-

formation corresponding to that LED is displayed on the electronic console.

c. Enter the diagnostics program (see Procedure 2.1) and log the power bits under loaded

and unloaded conditions.

3. If during step 2B, squeaking noises associated with the running deck were heard, check the

lubrication of the running deck studs. If necessary, apply silicon grease to all of the running

deck studs.

3. Press the STOP key. When the treadmill comes to a stop, view the electronic console as the

treadmill scans time, speed, distance and percent of lift.

4. Press the INCLINE ▲ key while viewing the electronic console. Confirm that the running

bed inclines and the incline display increments to 12% as the INCLINE ▲ key is pressed.

5. Press the INCLINE ▼ key while viewing the electronic console. Confirm that the running bed

returns to a level position and the incline display decrements to 0% as the INCLINE ▼ key is

pressed.

6. Turn off the treadmill with the circuit breaker, then unplug the treadmill from the wall outlet.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 72 73

No comments

Precor C954i Service Manual Page 13