Precor DISCOVERY SERIES_DBR0817 User Manual download pdf (Page 26)

Calf Raise Assembly Guide: Assembling the Equipment 8

Installing the Movement Arm

Before you attach the movement arm to the vertical frame, you must insert an

axle.

To insert the axle into the movement arm:

1. Slide the axle into the movement arm sleeve.

Figure 5: Axle and stop ring installation

2. Center the axle within the movement arm sleeve, then place a stop ring

over each end of the axle. Slide the stop rings as far in as they will go.

To attach the movement arm to the vertical frame:

1. Gently fit the movement arm into the bracket underneath the vertical

frame.

2. Attach the movement arm using two M12 x 35 mm socket head cap

screws and two 13 mm flat washers.

Important: The screws should be tight enough to prevent the movement arm

from rocking from side to side when in use.

Figure 6: Movement arm attachment

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

No comments

Precor DISCOVERY SERIES_DBR0817 User Manual Page 26