Precor DISCOVERY SERIES_DBR0817 User Manual download pdf (Page 30)

Calf Raise Assembly Guide: Assembling the Equipment 12

Installing the Knee and Seat Pads

The knee and seat pads on this equipment are attached directly to the

movement arm.

To install the pads:

1. Place the seat pad over the four screw holes on the movement arm.

2. Insert four ⁵₁₆-inch x 3¹₄-inch screws with 9 mm flat washers through the

screw holes on the movement arm and into the holes on the seat pad, as

shown in the following figure. Tighten the screws completely.

Figure 12: Seat pad attachment

3. Hold a knee pad up to the knee pad frame so that its narrow end faces the

center post. Insert two ⁵₁₆-inch x 3¹₄-inch screws with 9 mm flat washers

through the screw holes on the knee pad frame and into the holes on the

knee pad, as shown in the following figure. Tighten the screws completely.

Figure 13: Knee pad attachment

4. Repeat the previous step to attach the remaining knee pad.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Precor DISCOVERY SERIES_DBR0817 User Manual Page 30