Precor C932 User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
page 28
COMMERCIAL PRODUCTS DIVISION
150 LB (68 KG): Acceptable weight entries range from 1 through 999 (pounds or
kilograms). Change the number using theandkeys or accept the displayed
number (and continue in Setup mode) by pressing SELECT.
Important: Enter a number that reflects a user’s actual weight since the calorie
count and several other calculations are based on the weight entry.
AGE 0: The age prompt appears if the heart rate receiver is properly installed in the
display console. Acceptable entries range from 1 to 99. Change the blinking number
using theandkeys or accept the displayed number by pressing SELECT.
Important: An age entry is required if the user wants to use the heart rate capa-
bilities of the treadmill. Refer to Heart Rate Capabilities on page 44.
THE SETUP MODE AND THE QUICKSTART
TMTM
TMTM
TM
FEATURE
The QuickStart feature can be pressed any time during the Setup prompts. Since
the QuickStart program accesses factory default values (refer to
Club Information
on page 20) and assumes the age value is equal to zero, the SmartRate program
is disabled. However, the values that the QuickStart program uses are dependent
on when a user presses QuickStart in the Setup mode. See the table below.
CAUTION: Pressing the QuickStart key at the PRECOR banner or after any
one of the Setup prompts causes the running belt to begin moving auto-
matically. Hold onto the handrail because the belt starts moving after a
short warning message scrolls across the display,
Belt Starting 3, 2, 1,...
If QuickStart is pressed at the: The following occurs:
PRECOR banner The user bypasses the Setup prompts
altogether and starts working out using
the Manual course. Default values apply.
Course prompt The profile associated with the course
name (MANL, INTV, WTLS, etc.) appears
on the display and becomes the user’s
selection for their workout.
Workout Time prompt The information (XX MIN) that appears
on the display becomes the workout time
for the course. A user can change the dis-
play using theorkeys. See
Workout Tips
.
Note: A user can select an indefinite workout time, if the Club allows it. By pressing
either ▼▲ key, the word “NOLIM” appears on the display where the number zero
would normally appear (between 99 and 1). Refer to
Club Information
on page 20.
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Comments to this Manuals

No comments