Precor C932 User Manual download pdf (Page 22)

page 22

COMMERCIAL PRODUCTS DIVISION

SELECTING THE LANGUAGE

Display prompts can appear in English, German, Spanish, French, Dutch, or

Portuguese. Use the ▼▲ keys to display your preference and press SELECT.

DETERMINING THE UNITS OF MEASURE

The C932 can display units of measure in either U.S. Standard (miles, miles per

hour) or Metric (kilometers, kilometers per hour). When the treadmill is shipped

from the factory it is set to display U.S. Standard units of measure. You can easily

change this setting by taking the following steps:

1. Check that the C932 is ON. If necessary, turn ON the treadmill using the

power switch located at the front of the unit.

2. At the scrolling PRECOR banner, press the following keys in sequence:

RESET, SELECT, SPEED ▼ , SELECT, INCLINE ▲, SELECT, SPEED ▼, SELECT

Numbers appear associated with the key that you pressed: 5,6,5,1,5,6,5

Important: If the second key (SELECT) is not pressed within 1/2 second

after RESET, the display returns to the PRECOR banner and you need to

begin again.

3. The prompt, SELECT UNITS scrolls across the display and then, the current

unit of measure appears. The message scrolls continually until you press a

key. Any ▼ or ▲ key lets you alternate between the prompts.

4. Once your selection is displayed, three options exist. You can,

a. press the SELECT to accept the unit of measure being displayed and

continue with programming the treadmill. (Refer to

Determining the Club

Speed Limit

.) The changes are saved in memory. The C932 will retain

your selection even when it is turned OFF and unplugged.

b. press the red Stop button, which keeps the “current unit of measure”,

unchanged and advances to the next section.

Note: The “current unit of measure” is not necessarily the one being dis-

played. It refers to the unit of measure that was in existence prior to

entering the SELECT UNITS program.

c. press RESET, which keeps the “current unit of measure”, unchanged,

ends programming mode, and returns to the PRECOR banner.

Important: If you change the Unit of Measure display, be sure to check the

speed limit setting to verify that it is correct. Refer to Determining the Club

Speed Limit below.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

No comments

Precor C932 User Manual Page 22