Precor C932 User Manual download pdf (Page 16)

page 16

COMMERCIAL PRODUCTS DIVISION

12. Install fasteners in the handrail clamp. Diagram 11. Return to the center

handrail clamp and place a large washer (F) onto each of two screws (E).

Thread the screws through the handrail clamp. Finger tighten.

CAUTION: Do not overtighten the screws or you may inadvertently

cause stress cracks.

Diagram 12

Secure the fasteners.

First: Alternately

tighten four front

panel screws.

Third: Alternately

tighten the four

screws that secure

the console to the

uprights.

Second: Alternately

tighten four side

upright screws.

13. Tighten all mounting screws with the hex key (H) provided. Diagram 12.

Start at the front of the treadmill with the four screws that attach the upright

supports to the front panel. Tightening these screws first helps pull the rest

of the treadmill’s parts into alignment. Then, proceed with tightening the four

screws (A) that secure the upright supports and the four display console

assembly screws (C).

Important: For proper alignment, it is critical that the fasteners are

tightened in the order shown in Diagrams 12 and 13.

Diagram 11

Secure the upper handrail clamp.

Tighten the screws,

but leave room for

adjustments.

Washer (F) with

1½-inch screw (E)

Handrail clamp

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

No comments

Precor C932 User Manual Page 16