Precor CONSOLE P80 User Manual download pdf (Page 99)

Installing the Console 37

Completing the Console Installation (P80)

Before you complete the final installation steps, double-check

the connections you have made. Make sure that all cables are

fully and securely connected, and that any unneeded cables

are tied back properly.

To complete the installation:

1. Feed extra cable back into the neck tube.

2. Tilt the control console backward (toward yourself) until

the tab on the top edge of its back plate slides along the

top edge of the console mount and the screw holes align

properly.

3. Insert the four ⁵₈-inch flat head screws through the holes

in the console mount and thread them into the holes in

the back plate on the console. Partially tighten the screws

using a ⁵₈-inch hex wrench.

4. Line up the two small tabs at the top of the console’s back

cover with the slots at the top of the opening in the

console case. Insert the tabs into the slots.

5. Insert the remaining tabs on the back cover with the

corresponding slots on the console case.

6. Press gently on the edges of the back cover to snap it into

place.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 123 124

No comments

Precor CONSOLE P80 User Manual Page 99