Precor CONSOLE P80 User Manual download pdf (Page 81)

Assembling the Treadmill 19

3. Remove the seven screws holding the back cover in place.

Snap the back cover loose and set it aside, along with the

seven screws.

Figure 4: Removal and replacement of the rear fairing cover

4. Remove the two ends of the base unit data cable from the

left arm of the fairing (position 1 in the following

illustration). Route the shorter of the two cable ends into

the fairing and extend the long end outward.

Figure 5: Cable storage locations in the treadmill fairing: base

unit data cable (1) and Auto Stop cable (2)

5. Remove the Auto Stop cable from the tube on the

right-hand side of the fairing (position 2 in the preceding

illustration).

Important: In the following step, make sure that the end of

the data cable with the ferrite bead is the upper end. Likewise,

on the automatic stop sensor cable, the three-conductor

socket is the lower end and the four-conductor socket is the

upper end.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 123 124

No comments

Precor CONSOLE P80 User Manual Page 81