Precor EFX546 Service Manual download pdf (Page 50)

C546 Self Powered Elliptical Fitness Crosstrainer

Page 50

Procedure 7.13 - Replacing a Ramp Assembly

Procedure

1. Remove the rear cover and disconnect the red battery lead from terminal M6 of the lower

PCA.

2. Rotate both stairarms to the rear of the unit.

3. Remove the bolts that fasten the lift yoke into the ramp assembly. Slide the lift yoke out of

the ramp assembly and rotate the ramp assembly toward the rear of the unit.

4. Remove four rear ramp mounting bolts (2 each side). See Diagram 7.7.

Diagram 7.7 - Rear Ramp Mounting

5. Remove the ramp from the EFX. .

6. Set the ramp assembly at its mounting position. Hand start the four rear mounting bolts.

Slide the lift yoke ito the ramp and replace and hand tighten the yoke mountin bolts. Torque

the rear mounting bolts to 120 inch pounds. Torque the yoke mounting bolts to 240 inch

pounds.

7. Rotate both stairarms forward onto the ramp assembly.

8. Reconnect the red battery lead removed in step 1 and replace the rear cover.

Ramp

Mounting

Bolt

Mounting

Bracket

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 65 66

No comments

Precor EFX546 Service Manual Page 50