Precor C764 Service Manual download pdf (Page 77)

C762, C764, C764i Stairclimber

Page 77

Diagram 7.16 - The Disk Assembly

Replacing the Disk Assembly

6. Push the disk assembly through the drive belt hanging from the sheave shaft. Position the

belt against the disk hub and behind the drive belt idler as you slide the disk assembly into

the disk brackets. Push the disk in as far as possible.

Important

Make sure that the remote sensor assembly tabs straddle the disk target (refer back to Diagram

7.6). The outer nuts must be on the outside of the disk brackets.

7. Choose one:

IF... THEN...

You are replacing a Version A disk Continue with the next step

assembly

You are replacing a Version B disk Using a 17mm open-end wrench,

assembly tighten the outer nuts on each end of

the disk axle (see Diagram 7.16); then

skip to Step 15

Disk Assembly

Outer Nut

Inner Nut

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 102 103

No comments

Precor C764 Service Manual Page 77