Precor RBK 815 User Manual download pdf (Page 25)

Installing the Console 23

4. Route the twisted, red-and-black heart rate sensor cable

and the flat, gray base unit data cable to the left of the

mounting bracket and about three-quarters of the way up

the left side of the console, as shown in the following

illustration.

Figure 10: Routing the data and heart rate cables

5. Attach the base unit data cable to the eight-conductor

modular jack labeled LOWER BOARD CONNECTION.

6. Attach the heart rate sensor cable to the four-pin

connector labeled HEART RATE.

Note: The cables on the connector and the circuit board

can fit together in only one way. There may also be a

10-pin connector labeled HEART RATE, but it is not

compatible with the equipment.

Important: If you are installing a Cardio Theater screen or

receiver, complete the Cardio Theater installation before you

reattach the console’s rear cover.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 87 88

No comments

Precor RBK 815 User Manual Page 25