Precor C934 User Manual download pdf (Page 10)

page 10

COMMERCIAL PRODUCTS DIVISION

HARDWARE KIT

After unpacking the treadmill, open the hardware kit (refer to Diagram 2) and

make sure that you have the following items:

❑ (A) four 2-inch long socket head screws — mount upright supports to base

❑ (B) four barrel spacers — place on 2-inch screws

❑ (C) ten ¾-inch long socket head screws

❑ (D) sixteen flat washers

❑ (E) two 1½-inch socket head screws — handrail clamp assembly

❑ (F) four large diameter washers — place on handrail end cap screws

❑ (G) four 1-inch socket head screws — handrail mounting bracket

❑ (H) ¼-inch hex key — 3 inches by 10 inches

If any items are missing, refer to

Obtaining Service

on page 7.

Note: After assembling the treadmill, you will have four ¾-inch long socket head

screws (C) and two flat washers (D) remaining. You can discard them if you wish.

Also, be sure to store the hex key in a secure place. It is used for specific main-

tenance procedures that are described in the manual.

ADDITIONAL TOOLS NEEDED

Obtain the following tools

before

assembling the treadmill.

❑ Wire cutter ❑ ½-inch box end wrench

❑ Bubble level ❑ String

Diagram 2

Hardware kit.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Precor C934 User Manual Page 10